Avaya Nortel Communication Server 1000 Reference page 78

Circuit card installation
7. Insert the card into the card aligning guides in the card cage. Gently push the card
8. Lock the card into position by simultaneously pushing the ends of the locking
9. If there is an enable/disable switch, set it to Enb.
10. If you are adding a voice, conference, or tone and digit loop, press the manual
11. If you are installing the card in a working system, refer to the work order and the
12. Go to the appropriate test procedure in
78 Circuit Card Reference
into the slot until you feel resistance. The tip of the locking device must be behind
the edge of the card cage (see
cage on page 77).
devices against the faceplate.
Note:
When IPE cards are installed, the red LED on the faceplate remains lit for two to
five seconds as a self-test runs. If the self-test is completed successfully, the LED
flashes three times and remains lit until the card is configured and enabled in
software, then the LED goes out. If the LED does not follow the pattern described
or operates in any other manner (such as continually flashing or remaining weakly
lit), replace the card.
Note:
Do not enable the switch on an NT8D04 Superloop Network card or QPC414
Network card until network loop cables are installed.
initialize (Man Int) button on the NT5D03 or the NT5D10 Call Processor if the card
is associated with the active Call Processor:
Note:
An initialization causes a momentary interruption in call processing.
technical document, Software Input/Output Reference — Administration
(NN43001-611) to add the required office data to the system memory.
Comments? infodev@avaya.com
Figure 16: Installing the circuit card in the card
Acceptance tests on page 79.
July 2011