Avaya Nortel Communication Server 1000 Reference page 34

Overview
IPE line cards can be installed in any slot of the NT8D37 IPE module.
shown installed in an NT8D37 IPE module
installed in an NT8D37 IPE module.
Figure 1: IPE line cards shown installed in an NT8D37 IPE module
When installing line cards, follow these general procedures:
1. Configure the jumpers and switches on the line card (if any) to meet system
2. Install the line card into the selected slot.
3. Install the cable that connects the backplane connector on the IPE module to the
4. Connect a 25-pair cable from the module I/O panel connector to the Main
5. Connect the line card output to the selected terminal equipment at the MDF.
6. Configure the individual line interface unit using the Analog (500/2500-type)
Once these steps are complete, the terminal equipment is ready for use.
Operation
This section describes how line cards fit into the CS 1000E, CS 1000M, and Meridian 1
architecture, the busses that carry signals to and from the line cards, and how they connect to
34 Circuit Card Reference
needs.
module I/O panel.
Distribution Frame (MDF).
Telephone Administration program LD 10 for analog line interface units and Multi-
line Telephone Administration program LD 11 for digital line interface units.
Comments? infodev@avaya.com
on page 34 shows where an IPE line card can be
Figure 1: IPE line cards
July 2011