Chapter 22: NT8D15 E and M Trunk card
Contents
This section contains information on the following topics:
Introduction
Physical description
Functional description
Operation
Electrical specifications
Connector pin assignments
Configuration
Applications
Introduction
The NT8D15 E and M Trunk card interfaces four analog telephone trunks to the switch. Each
trunk interface connects to a trunk facility using tip and ring leads that carry voice, ringing, and
tone signaling, and to signaling interfaces by E and M leads. Each unit can be configured
independently by software control in the Trunk Data Block (or Trunk Administration) program
LD 14.
You can install this card in any IPE slot.
Note:
Up to four analog trunk cards are supported in each Media Gateway and Media Gateway
Expansion.
The NT8D15 E and M Trunk card supports the following types of trunks:
• 2-wire E and M Type I signaling trunks
• two-wire dial repeating trunks
Circuit Card Reference
on page 431
on page 432
on page 434
on page 441
on page 450
on page 452
on page 455
on page 459
July 2011
431