Avaya Nortel Communication Server 1000 Reference page 469

SW15
SW16
* To enable ports 1 and 2, set SW15 position 1 to ON. To enable ports 3 and 4, set SW16
position 1 to ON.
is not used.
Address
Switch SW15 or SW16 and logic on the card always address the four UARTs using a pair of
addresses: 0 and 1, 2 and 3 through 14 and 15. The settings for both switches are shown in
Table 199: NT8D41BA address switch settings
switches SW15 and SW16 must not be configured identically.
paddle board
Table 199: NT8D41BA address switch settings
SW15
SW16
Device
pair
addresses
* To enable ports 1 and 2, set SW15 position 1 to ON. To enable ports 3 and 4, set SW16
position 1 to ON.
For each X, the setting for this switch makes no difference, because it is not used.
DTE/DCE/Fiber mode
Each serial port can be configured to connect to a terminal (DTE equipment), a modem (DCE
equipment), or a Fiber Superloop Network card. Instructions for setting the switches SW2,
SW3, SW4, SW5, SW6, SW7, SW8, and SW9 are shown in
Fiber switch settings
shows the location of these switches on the paddleboard.
Circuit Card Reference
Port 1 Port 2
Port 3 Port 4
+
For each X, the setting for this switch makes no difference, because it
on page 465 displays SW15 and SW16.
Port 1 Port 2
Port 3 Port 4
0 1
2 3
4 5
6 7
8 9
10 11
12 13
14 15
on page 470. Figure 148: NT8D41BA QSDI paddle board
Switch settings
+
1* 2 3 4
on page 469. To avoid system problems,
Switch settings
+
1* 2 3 4
E X off off
E X off off
E X off off
E X off off
E X off off
E X off off
E X off off
E X off off
Configuring the QSDI paddle board
5 6 7 8
Figure 148: NT8D41BA QSDI
5 6 7 8
off off off off
off off off on
off off on off
off off on on
off on off off
off on off on
off on on off
off on on on
Table 200: NT8D41BA DTE/DCE/
on page 465
July 2011 469