Chapter 17: NT6D71 UILC line card
Contents
This section contains information on the following topics:
Introduction
Physical description
Functional description
Introduction
The NT6D71 U Interface Line card (UILC) supports the OSI physical layer (Layer 1) protocol.
The UILC is an ANSI-defined standard interface. The UILC provides eight two-wire full-duplex
(not polarity sensitive) U interfaces to connect ISDN BRI-compatible terminals over Digital
Subscriber Loops (DSL) to the CS 1000E, CS 1000M, and Meridian 1. A description of the
ISDN BRI feature is contained in ISDN Basic Rate Interface: Installation and Configuration
(NN43001-318).
You can install this card in any IPE slot.
Note:
A maximum of four UILCs are supported in an Media Gateway and Media Gateway
Expansion.
The NT6D71 U Interface Line Card (UILC) supports the OSI physical layer (Layer 1) protocol.
The UILC is an ANSI defined standard interface. The UILC provides eight two-wire full duplex
(not polarity sensitive) U interfaces that are used to connect ISDN BRI compatible terminals
over DSLs to the Meridian 1. A description of the ISDN BRI feature is contained in ISDN Basic
Rate Interface: Maintenance (NN43001-718).
The NT6D71 U Interface Line Card (UILC) supports the OSI physical layer (Layer 1) protocol.
The UILC is an ANSI-defined standard interface. The UILC provides eight two-wire full-duplex
(not polarity sensitive) U interfaces to connect ISDN BRI-compatible terminals over Digital
Subscriber Loops (DSL) to the CS 1000. For more information about ISDN BRI, see
BRI
on page 304.
Circuit Card Reference
on page 311
on page 312
on page 312
ISDN
July 2011
311