Overload Level; Environmental Specifications; Connector Pin Assignments - Avaya Nortel Communication Server 1000 Reference

Circuit card reference
Hide thumbs Also See for Nortel Communication Server 1000:
Table of Contents

Advertisement

Overload level

Signal levels exceeding +7 dBm applied to the tip and ring cause distortion in speech
transmission.

Environmental specifications

Table 166: Analog message waiting line card - environmental specifications
the environmental specifications for the analog message waiting line card.
Table 166: Analog message waiting line card - environmental specifications
Operating temperature
Operating humidity
Storage temperature

Connector pin assignments

The analog message waiting line card brings the 16 phone lines to the IPE backplane through
a 160-pin connector shroud. The backplane is cabled to the I/O panel on the rear of the module,
which is then connected to the MDF by 25-pair cables.
Telephone lines from station equipment cross connect to the analog message waiting line card
at the MDF using a wiring plan similar to that used for trunk cards. A typical connection example
is shown in
example
on page 375 and
pinouts
on page 374shows the I/O pin designations at the backplane connector. This
connector is arranged as an 80-row by 2-column array of pins. Normally, these pin positions
are cabled to 50-pin connectors at the I/O panel in the rear of each module for connection with
25-pair cables to the cross-connect terminal.
The information in
page 374is provided as a reference and diagnostic aid at the backplane, because the cabling
arrangement may vary at the I/O panel. See Communication Server 1000M and Meridian 1
Large System Installation and Configuration (NN43021-310) for cable pinout information at the
I/O panel.
Circuit Card Reference
Parameter
Figure 101: Analog message waiting line card - typical cross connection
Table 167: Analog message waiting line card - backplane
Table 167: Analog message waiting line card - backplane pinouts
Specifications
0° to +60° C (+32 to +140° F), ambient
5 to 95% RH (non-condensing)
–40° to +70° C (–40° to +158° F)
Connector pin assignments
on page 373 lists
on
July 2011
373

Advertisement

Table of Contents
loading

Table of Contents