Chapter 25: NTAK02 SDI/DCH card
Contents
This section contains information on the following topics:
Introduction
NTAK02 SDI/DCH card
Introduction
The NTAK02 Serial Data Interface/D-channel (SDI/DCH) digital trunk card is supported in the
Media Gateway only for the ISDN Signaling Link (ISL) D-channel.
You can install this card in slots 1 through 4 in the Media Gateway. It is not supported in the
Media Gateway Expansion. Up to four NTAK02 SDI/DCH cards are supported in a Media
Gateway.
NTAK02 SDI/DCH card
The optional SDI/DCH card provides up to four serial I/O ports, which are grouped into two
pairs:
• port 0 and port 1
• port 2 and port 3
Ports 1 and 3 are configured as DCH. Ports 0 and 2 are configured as SDI (not supported).
See
Table 209: Port configurations
in
Table 210: Switch settings
Table 209: Port configurations
Port 0
Port 1
Circuit Card Reference
on page 485
on page 485
on page 486.
on page 485. Each pair is controlled by a switch, as shown
SDI (not supported)
DCH
July 2011
485