Figure 101: Analog message waiting line card - typical cross connection example
Configuration
This section outlines the procedures for configuring the switches and jumpers on the NT8D09
Analog Message Waiting Line card and configuring the system software to properly recognize
the card.
Figure 102: Analog message waiting line card - jumper block and switch locations
page 377 shows where the switches and jumper blocks are located on this board.
Jumper and switch settings
The NT8D09 Analog Message Waiting Line card has no user-configurable jumpers or switches.
The card derives its address from its position in the backplane and reports that information
back to the CPU through the LAN Link interface.
Circuit Card Reference
Configuration
on
July 2011
375