Add Did Trunks - Avaya S8700 Manual

3
Install the CO trunk circuit pack in the assigned carrier slot.
Use the correct type of trunk circuit pack with enough ports to handle the number of trunks you
need. Refer to the Hardware Guide for Avaya Communication Manager to find out how many
circuit packs you need.
4
Administer the screens listed under Adding a CO, FX, or WATS Trunk Group and Adding a
PCOL Trunk Group in the Administrator's Guide for the Avaya Communication Manager.

Add DID Trunks

Each Direct Inward Dial (DID) trunk connects to 1 port of a DID Trunk circuit pack or to 1 port of an
assortment of global DID/DIOD trunk circuit packs.
Before physically installing the circuit pack, you need the assigned slot location (UUCSS), where UU is
the media gateway (MCC1) or port network number (G650), C is the media gateway (G650) or carrier
(MCC1), and SS is the slot location. The information is available from the person who administered the
translations (most likely the software specialist). If not, you can find the information on the Trunk Group
Status screen.
1
Get the trunk group number from the administrator.
2
Type status trunk-group number and press
status trunk 1
Member Port
0001/001 13A0701
0001/002 13A0702
0001/003 13A0703
0001/004 13A0704
0001/005 13A0705
0001/006 13A0706
0001/007 13A0707
0001/008 13A0708
0001/009 13A0801
0001/010 13A0802
0001/011 13A0803
0001/012 13A0804
0001/013 13A0805
0001/014 13A0806
3
Install a DID/DIOD trunk circuit pack in the assigned carrier slot.
4
Administer the screens listed under Adding a DID Trunk Group in the Administrator's Guide for
the Avaya Communication Manager.
Adding New Hardware--S8700
November 2003
TRUNK GROUP STATUS
Service State Mtce Connected Ports
Busy
in-service/idle no
in-service/idle no
in-service/idle no
in-service/idle no
in-service/idle no
in-service/idle no
in-service/idle no
in-service/idle no
out-of-service
out-of-service
out-of-service
out-of-service
out-of-service
out-of-service
Install and Administer Trunks and Lines
.
Enter
37