Connecting To The Ports - Avaya Nortel Communication Server 1000 Reference

NTAK02 SDI/DCH card
Port 2
Port 3
Table 210: Switch settings
SDI (not supported)
SDI (not supported)
—
SDI (not supported)
SDI (not supported)
—
Note:
Digital Private Network Signaling System DPNSS can replace the DCH function in the
U.K.
Two ports offer the option for DTE/DCE configuration. This option is selected from a jumper
on the card.
Table 211: Jumper settings
Port
0
1
2
3

Connecting to the ports

External devices are connected to the SDI/DCH card by the following:
• the NTAK19FB four-port SDI cable. This cable does not have to be terminated at the cross
connect terminal because it is equipped with connectors.
• the NE-A25-B cable. Terminate the NE-A25-B cable at the cross connect terminal. Tables
Table 212: NTAK02 pinouts - Port 0 at the cross-connect terminal
486 Circuit Card Reference
Port 0
Port 2
Table 211: Jumper settings
Jumper Strap for
location DTE
J10 C - B
J7J6 C - BC -
B
J5 C - B
J4 J3 C - BC -
B
Comments? infodev@avaya.com
SDI (not supported)
DCH
Port 1 SW 1-1
DCH OFF
DCH OFF
ESDI ON
Port 3 SW 1-3
DCH OFF
DCH OFF
ESDI ON
on page 486 shows the jumper settings.
Strap for Jumper
DCE location
B - A
B - AB - A J9 J8
B - A
B - AB - A J2 J1
SW 1-2
OFF
ON
ON
SW 1-4
OFF
ON
ON
RS422 RS232
C - BC - B - AB - A
B
C - BC - B - AB - A
B
on page 487 through
July 2011