Set Mode - Avaya Nortel Communication Server 1000 Reference

disconnect message. A YES response to the S S command, the default configuration for
Release 2 (and later) boards, configures the LEI to operate in this way. See
Simple (S S) yes screen
Figure 53: Set Simple (S S) no screen
Figure 54: Set Simple (S S) yes screen

Set Mode

At the SET MODE (S M) command, the MMI prompts the user with the current signaling mode,
either Default (Australian P2) or Table (of bit values.) Entering a <CR> accepts the current
value, or the user can type in 1 to revert to the Default, or 2 to edit the table entries. See
55: Set Mode screen
to the Default values.
Responding to the MMI's Set Mode prompt with "1" also results in the line "Signaling Bits set
to Default," as in
Figure 55: Set Mode screen
However, responding to this prompt with 2 selects "Table" and allows the user to set the A/B
Bit Mode to whatever configuration the user chooses.
If "Table" is selected, the individual table values are prompted for. See
M): Table screen
After each value is displayed, enter <CR> to do the following:
• accept the current value
• enter just the AB bits (which is copied to the CD bits)
Circuit Card Reference
on page 231.
on page 231. If the user selects default, then the A/B Bit values is reset
Figure 55: Set Mode screen
on page 232 and Figure 57: Set Mode (S M): Table screen
Man-Machine E1 maintenance interface software
on page 231.
Figure 54: Set
Figure
Figure 56: Set Mode (S
on page 233.
July 2011 231