Rep 10.1 Ela Hou - Fuser Assembly - Xerox WorkCentre M20 Service Manual

2
Remove the PMO - guide
paper out.
IPR - GND
input.
Figure 4 ELA HOU - pickup plus assembly removal
Replacement
Replacement is the reverse of the removal procedure. When reinstalling the MEA unit guide
CST PA assembly, ensure the PMO sheet guide paper, PL 4.25 Item 11 and the mylar strips,
PL 4.25 Item 12 are not damaged.
Work Centre M20 Family

REP 10.1 ELA HOU - Fuser Assembly

1
Parts List on PL 9.10
Unclip the sensor cover.
Removal
Switch off the electricity to the machine. Disconnect the power cord from the customer
supply while performing tasks that do not need electricity. Electricity can cause death or
injury. Moving parts can cause injury.
Take care during this procedure. Sharp edges may be present that can cause injury.
Do not touch the fuser while it is hot.
Before performing this procedure, refer to General Disassembly Precautions, GP 10.
NOTE: If necessary, refer to GP 20 for the acronym list and cross reference lists of more com-
monly recognised part names.
4
1. Open the ELA HOU - side cover assembly, PL 8.10 Item 1.
Release the harnesses.
NOTE: For clarity, the ELA HOU - side cover assembly is shown removed from the machine in
Figure 1, Figure 2 and Figure 3.
3
2. Remove the cover sheet connector, Figure 1.
Remove 5 screws, then
the ELA HOU - pickup
plus assembly.
March 2004
4-29
WARNING
WARNING
WARNING
CAUTION
1
Remove 1 screw, then
the cover sheet connec-
tor.
Figure 1 Cover sheet connector removal
Repairs and Adjustments
REP 8.6, REP 10.1