Install New Firmware On The G700 Media Gateway Processor - Avaya G700 Installation Manual

b. At the P330-1(super)# prompt, type dir <module #>
Check the version number in the ver num column for the "EW_Archive" file.
M# file
-- -------------
1 module-config
1 stack-config
1 EW_Archive
1 Booter_Image

Install New Firmware on the G700 Media Gateway Processor

Follow this procedure to upgrade the firmware on the media gateway processor (MGP).
1. If not already connected, telnet to the P330 stack processor and login.
2. Type session mgp to reach the G700 Media Gateway processor.
3. At the MG-001-1(super)# prompt, type configure to enter configuration mode.
4. At the MG-001-1(configure)# prompt, type show mgp bootimage to determine which
disk partition (bank) is Active Now.
You will update the bank that is not listed as Active Now. For example, if Bank A is listed
under ACTIVE NOW, you will upgrade bank B.
FLASH MEMORY
Bank A
Bank B
ACTIVE NOW
Bank A(22.16.0)
5. At the MG-001-1(configure)# prompt, type
copy tftp mgp-image <bank> <image-file> <tftp_server_ip_address>,
where
<bank> is the bank (A or B) that is not Active Now.
<image-file> is the filename of the firmware image file; for example,
mgp_22_16_0.bin.
ver num file type
------- ------------
N/A Running Conf Ram
N/A Running Conf
4.0.4 SW Web Image
3.2.5 SW Boot Image Nv-Ram
IMAGE VERSION
22.16.0
22.15.0
ACTIVE AFTER REBOOT
Bank A(22.16.0)
Install New Firmware on the G700 Media Gateway
file file
location description
-------- ----------------
Module Configuration
Ram Stack Configuration
Nv-Ram WEB Download
Booter Image
555-245-758 Issue 4 February 2006 15