Administer The Ip Connections; List Configuration Board - Avaya CMC1 Installation, Upgrades And Additions

Note:
If the TN2501AP or TN750 circuit packs are at the system limit and you insert a
Note:
VAL circuit pack, the red LED on that circuit pack stays on, indicating that the
system does not accept it.
3. Connect the Backplane Adapter
switch cabinet, corresponding to the TN2501AP circuit pack slot.
4. Connect the LAN cable to the RJ-45 connector on the Backplane Adapter.

Administer the IP connections

Use the following commands to administer the IP connections of the announcement circuit
pack.

list configuration board

To ensure that the switch recognizes the TN2501AP circuit pack after it is latched in the carrier
slot.
1. At the SAT, type list configuration board board-location and press RETURN.
The System Configuration report appears.
Figure 86: System Configuration screen (list configuration board)
list configuration board 1c08
Board
Number
01C08
Command successfully completed
2. Verify the following field values:
Board Type shows VAL-ANNOUNCEMENT
Code is TN2501AP
(Figure
Board Type
VAL-ANNOUNCEMENT
Add Integrated Announcements/TN2501AP
85) to the Amphenol connector on the back of the
SYSTEM CONFIGURATION
Code Vintage
TN2501AP HW00 FW001 01 02 03 04 05 06 07 08
SPE A
Assigned Ports
u=unassigned t=tti p=psa
09 10 11 12 13 14 15 16
17 18 19 20 21 22 23 24
25 26 27 28 29 30 31 32
U
Issue 10 June 2005 263