Camshaft/Rocker Arms - Arctic Cat 700 Diesel ATV 2007 Service Manual

10. Install the timing belt (see Left-Side Components
in this section).
11. Install the valve cover using a new gasket; then
secure with the ten cap screws and using a criss-
cross pattern, tighten to specifications.
! CAUTION
Always use a new gasket and drain seal when install-
ing the valve cover. The valve cover gasket is a criti-
cal component in the lubrication system. Severe
engine damage may occur if the gasket is not
replaced.
12. Install the air filter assembly and connect and
secure all intake hoses.
13. Install the front body panel and front rack (see
Section 8).
Back
DE262
DE407
DE074A
Back to TOC

CAMSHAFT/ROCKER ARMS

Removing
1. Remove the timing belt (see Left-Side Compo-
nents in this section).
2. Remove the front rack and front body (see section
8); then remove the air filter assembly and mount-
ing bracket, and air diverter with ducts.
3. Use duct tape to cover the engine air intake boot to
prevent dirt or debris from entering the engine.
4. Disconnect the oil pressure switch connector from
the switch located on the right side of the valve
cover; then remove the fuel lift pump (see Lift
Pump in Section 4).
5. Disconnect the crankcase breather hose from the
right front corner of the valve cover.
Back to Section TOC
3
DE074A
DE516A
DE077B
Next
3-13