Front Rack; Front Bumper Assembly; Front/Rear Body Panel - Arctic Cat 700 Diesel ATV 2007 Service Manual

12. If the difference in the measurements is not within
specifications, adjust both tie rods equally until
within specifications.
NOTE: Prior to locking the jam nuts, make sure
the ball joints are at the center of their normal
range of motion and at the correct angle.

Front Rack

REMOVING
1. Remove the two cap screws and lock nuts securing
the front fender panel.
2. Remove the cap screws and lock nuts securing the
rack to the frame.
3. Remove the front rack from the ATV.
CLEANING AND INSPECTING
NOTE: Whenever a part is worn excessively,
cracked, or damaged in any way, replacement is
necessary.
1. Clean all rack components.
2. Inspect all welds for cracking or bending.
3. Inspect threaded areas of all mounting bosses for
stripping.
4. Inspect for missing decals and/or reflectors.
INSTALLING
1. Place the rack into position on the frame and front
fender panel. Install the cap screws and lock nuts
and finger-tighten only.
2. Install the two cap screws and lock nuts securing
the rack to the fenders. Tighten all hardware
securely.
Back
8-8
733-559A
Back to TOC

Front Bumper Assembly

REMOVING
1. Remove the two flange bolts and lock nuts secur-
ing the upper bumper supports to the bumper.
2. Remove the through-bolt and lock nut securing the
bumper to the frame; then remove the bumper.
CLEANING AND INSPECTING
NOTE: Whenever a part is worn excessively,
cracked, or damaged in any way, replacement is
necessary.
1. Clean all bumper components.
2. Inspect all welds for cracking or bending.
INSTALLING
1. Place the front bumper assembly into position and
install the through-bolt. Start the lock nut and fin-
ger-tighten only.
2. Install the two flange bolts and lock nuts on the
upper supports. Tighten all hardware securely.

Front/Rear Body Panel

REMOVING
1. Remove the seat; then remove the tool tray.
2. Remove the negative battery cable.
3. Remove the reinstallable rivets securing the steer-
ing post cover and the radiator access cover; then
remove the covers.
4. Remove the left-side and right-side fender splash
panels; then remove one press-in fastener and one
reinstallable rivet from the left side and right side
of the air-intake splash shroud. Do not remove the
shroud.
5. Disconnect the four headlight connectors and the
taillight/brakelight connector from the sockets.
Back to Section TOC
Next