Arctic Cat 700 Diesel ATV 2007 Service Manual page 88

16. Subtract the crankshaft journal measurement from
the corresponding main bearing bore. The clear-
ance must be within specifications.
17. Install the bearing inserts to be used for assembly
in the connecting rods; then secure the connecting
rod in a suitable holding fixture.
Back
DE619
DE609A
DE614A
DE368
Back to TOC
! CAUTION
If a vise is used to secure the connecting rod it must
have brass, copper, or hardwood jaws to prevent
damage to the connecting rod. Never use a bench
vise without jaw protection or severe damage to the
connecting rod and engine will occur.
18. Tighten the connecting rod cap screws to specifi-
cations.
19. Using an appropriate inside micrometer, measure
the inside diameter of the connecting rod bearing
insert. It must be within specifications or the bear-
ings or connecting rod must be replaced.
20. Measure the inside diameter of the connecting rod
piston pin bushing. It must be within specifica-
tions.
Back to Section TOC
3
DE352
DE612
DE366
Next
3-65