Front Differential - Arctic Cat 700 Diesel ATV 2007 Service Manual

NOTE: It is important to tighten this cap screw
while the others are loose to ensure proper seating
of the actuator.
5. Tighten the remaining cap screws; then connect
the electrical plug to the main harness.
6. Turn the ignition switch to the ON position and
check the operation by shifting the selector switch
several times.
7. Secure the wiring harness to the frame with a
nylon cable tie; then install the inner fender panel.

Front Differential

NOTE: To remove the rear gear case, see Rear
Gear Case in this section.
REMOVING DIFFERENTIAL
1. Secure the ATV on a support stand to elevate the
wheels.
! WARNING
Make sure the ATV is solidly supported on the sup-
port stand to avoid injury.
2. Remove the drain plug and drain the gear lubricant
into a drain pan; then reinstall the plug.
Back
6-4
AG926
CF107B
Back to TOC
3. Remove the front wheels; then remove the front
inner fender panels.
4. Compress the hand brake; then engage the brake
lever lock.
5. Remove the cotter pin securing the hex nut; then
remove the hex nut and washer.
6. Release the brake lever lock.
NOTE: It is not necessary to remove the brake
hoses from the calipers for this procedure.
7. Remove the two brake calipers. Account for the
four cap screws and four 0.76 mm (0.030 in.)
spacer washers.
8. Remove the tie rod cotter pins and discard the
pins.
9. Remove the tie rod lock nuts.
Back to Section TOC
KX041
AF894D
AF895D
Next