Arctic Cat 700 Diesel ATV 2007 Service Manual page 96

4. Install the PTO/flywheel onto the crankshaft and
secure with five cap screws. Tighten to specifica-
tions.
5. Install the fixed drive face onto the PTO shaft;
then loop the drive belt around the driven pulley
and install onto the input shaft by looping the belt
over the fixed drive clutch hub. Make sure to ori-
ent the belt correctly if directional arrows are
present.
Back
DE487
DE476
DE479
Back to TOC
6. Secure the driven pulley with a flat washer and
nut; then tighten the nut to specifications.
7. Install the movable drive clutch face and V-belt
cover (see Section 2).
ENGINE/TRANSMISSION
1. Attach a suitable lift and place the engine/trans-
mission assembly into the frame from the left side
tilting the engine forward sufficiently to clear the
frame tube.
2. Maneuver the engine/transmission into position in
the frame; then install the front propeller shaft into
the front output yoke.
3. Align and connect the rear propeller shaft to the
rear output drive flange and secure with four cap
screws; then align and secure the front propeller
shaft to the differential input flange.
Back to Section TOC
DE488
3
DE084A
DE084B
Next
3-73