4. Place the control spool, thrust bearing, and thrust
washer into the governor flyweight assembly; then
using a rubber band, secure the weights around the
control spool.
5. Apply clean engine oil to the governor assembly
and install on the camshaft; then hold the fly-
weight assembly and remove the rubber band.
Install a new O-ring on the camshaft.
Back
DE278A
DE531
DE535
Back to TOC
6. Using a new O-ring, install the camshaft support
housing and tighten the cap screws to specifica-
tions.
7. Install the camshaft drive pulley and cap screw;
then using a suitable holding tool, tighten the cap
screw to specifications.
Back to Section TOC
DE536
3
DE537
DE245A
DE262
Next
3-19