Arctic Cat 700 Diesel ATV 2007 Service Manual page 163

! CAUTION
Use extreme care when removing the bearing. If the
bearing is allowed to fall, it will be damaged and will
have to be replaced.
CLEANING AND INSPECTING
NOTE: Whenever a part is worn excessively,
cracked, or damaged in any way, replacement is
necessary.
1. Clean all knuckle components.
2. Inspect the bearing for pits, gouges, rusting, or
premature wear.
3. Inspect the knuckle for cracks, breaks, or porosity.
4. Inspect threads for stripping or damage.
ASSEMBLING AND INSTALLING
1. Install the bearing; then install the snap ring mak-
ing sure it seats into the knuckle.
Back
PR287A
PR288
Back to TOC
2. Install the knuckle to the upper and lower ball
joints and secure with the two cap screws. Tighten
to specifications.
3. Install the tie rod end and secure with the nut.
Tighten to specifications; then install a new cotter
pin and spread the pin.
NOTE: During assembling, new cotter pins
should be installed.
4. Apply a small amount of grease to the hub splines.
Back to Section TOC
PR287A
AF760D
8
AF759D
Next
8-5