Arctic Cat 700 Diesel ATV 2007 Service Manual page 139

5. Install the pinion housing.
Removing/Installing Axle Seal
NOTE: This procedure can be performed on a
rear gear case.
1. Remove the seal using a seal removal tool.
2. Using a press, remove the bearing.
3. Using a press, install the new bearing into the
housing.
Back
CC891
CC899
CC900
Back to TOC
NOTE: Prior to installing the seal, apply grease
to the seal outside diameter.
4. Install the seal into the housing pressing evenly on
the outside edge until the seal is seated.
5. Repeat steps 1-4 for the opposite side.
INSTALLING DIFFERENTIAL
1. Place the differential into position on the frame
and install the cap screws, washers, and flex-lock
nuts. Tighten to specifications.
2. Align the front drive flange and the front drive
coupler; then secure with the existing hardware.
Back to Section TOC
CC901
CD018
6
DE081A
Next
6-15