Arctic Cat 700 Diesel ATV 2007 Service Manual page 34

4. Coat all serviceable parts with clean engine oil.
Assembling/Installing
1. Install the governor fork assembly into the cylin-
der head and secure with the governor fork pivot
pin. Tighten securely.
2. Using a new copper washer, install the torque set-
ting screw assembly and tighten securely; then
install the safety cover. Make sure the torque lim-
iter spool engages the limiter fork.
3. Using a new gasket, install the intake mani-
fold/throttle control assembly by first connecting
the high/low speed spring assembly to the throttle
control arm; then place the manifold and gasket
into position and secure with the seven cap screws.
Tighten securely.
Back
DE282
DE288A
DE258A
Back to TOC
4. Install the fuel injection control rack making sure
the slotted end engages the governor linkage
sleeve; then tighten the cap screws to specifica-
tions.
5. Connect the throttle linkage into the throttle con-
trol lever; then secure with the E-clip.
6. Place control spool, thrust bearing, and thrust
washer into the governor flyweight assembly and
secure the flyweights with a rubber band; then
place assembly onto the camshaft with a new
O-ring. Make sure to remove the rubber band.
Back to Section TOC
DE248A
3
DE534A
DE249A
Next
3-11