Arctic Cat 700 Diesel ATV 2007 Service Manual page 77

The countershaft is now assembled and ready for
installation.
AT THIS POINT
If the drive bevel gear assembly or secondary output
shaft assemblies were disassembled, use the follow-
ing procedure to assemble them.
9. Install new output drive bearings in the left and
right transmission cases; then install the output
shaft into the right-side transmission bearing.
10. Install the output driven gear, shims, drive bevel
gear, and washer onto the secondary output shaft;
then install a new retaining nut and tighten to spec-
ifications. Stake the retaining nut to the shaft.
11. Install a shim, front driven shaft bearing, driven
shaft seal, and yoke on the front of the output
driven shaft; then secure with a washer and nut.
Tighten to specifications and stake the nut to the
shaft.
Back
3-54
DE145A
DE167A
Back to TOC
12. Install the rear drive gear bearing, oil seal, and out-
put drive flange to the rear of the output driven
shaft; then secure with a washer and nut. Tighten
to specifications and stake the nut.
NOTE: The drive bevel gear and secondary out-
put shaft assemblies are now ready for installa-
tion.
Assembling Gear Case
1. Install new bearings and seals in the left-side and
right-side cases as required.
Back to Section TOC
DE147
DE149A
DE148A
Next