Arctic Cat 700 Diesel ATV 2007 Service Manual page 132

2. Install the input shaft seal making sure it is flush
with the edge of the housing.
3. Lubricate the input shaft splines with High-Perfor-
mance Grease (p/n 0436-905).
NOTE: Any time drive splines are separated,
clean all splines with parts-cleaning solvent and
dry with compressed air; then lubricate with rec-
ommended grease.
Back
6-8
AF993
AF994
KX221
Back to TOC
4. Install the input shaft into the pinion housing; then
secure with a snap ring.
5. Place the pinion housing with new gasket onto the
gear case housing; then secure with the existing
cap screws. Tighten to specifications.
NOTE: If a new gear case housing is being
installed, tighten the cap screws to 3.5-4.3 kg-m
(25-31 ft-lb).
Disassembling Pinion Gear
NOTE: This procedure can be performed on a
rear gear case.
1. Using a T-40 torx wrench, remove the cap screws
securing the pinion housing. Account for the cou-
pler, fork, and spring.
Back to Section TOC
KX222
KX210A
CD103
Next