Arctic Cat 700 Diesel ATV 2007 Service Manual page 154

CLEANING AND INSPECTING
NOTE: Whenever a part is worn excessively,
cracked, or damaged in any way, replacement is
necessary.
1. Thoroughly clean all A-arm components using a
pressure washer.
2. Clean the ball joint mounting hole of all residual
Loctite, grease, oil, or dirt for installing purposes.
3. Inspect the A-arm for bends, cracks, and worn
bushings.
4. Inspect the ball joint mounting holes for cracks or
damage.
5. Inspect the frame mounts for signs of damage,
wear, or weldment damage.
INSTALLING
1. Apply green Loctite #609 to the entire outside
diameter of the ball joint; then install the ball joint
into the A-arm and secure with the snap ring.
2. Install the A-arm assemblies into the frame
mounts and secure with the cap screws. Only fin-
ger-tighten at this time.
Back
7-4
AF616D
AF616D
Back to TOC
3. Route the brake hose through the upper A-arm
shock absorber mount; then secure the hose to the
A-arm with a cable tie and grommet.
4. Secure the lower eyelet of the shock absorber to
the upper A-arm. Tighten nut to specifications.
5. Secure the A-arm assemblies to the frame mounts
(from step 2). Tighten the cap screws to specifica-
tions.
! CAUTION
Do not tighten the nut beyond the 4.8 kg-m (35 ft-lb)
specification or the shock eyelet or mount WILL be
damaged.
6. Install the knuckle assembly onto the ball joints
and secure with cap screws. Tighten to specifica-
tions.
Back to Section TOC
AF610D
DE054A
AF628D
Next