Arctic Cat 700 Diesel ATV 2007 Service Manual page 43

AT THIS POINT
If the cylinder head has been removed, no more
components may be installed prior to installation on
the engine block. If the cylinder head has not been
removed, proceed to step 8.
8. Lubricate all rocker shaft components with clean
engine oil; then install the rocker arm assembly on
the cylinder head making sure the injector push
rods are correctly installed in their respective
injectors.
9. Rotate the camshaft until the camshaft lobes are
facing away from the rocker arms; then secure the
rocker arm support with the flat washers and nuts.
Tighten to specifications.
10. Install the timing belt (see Left-Side Components
in this section).
Back
3-20
DE529
DE571
DE260C
Back to TOC
11. Check adjustment of all valves (see Top-Side
Components in this section).
12. Place a small bead of high-temperature sealant on
both sides of the fuel rail seal; then carefully
install the valve cover with a new gasket and oil
return boot. Secure with existing hardware.
13. Using a crisscross pattern, tighten the Allen-head
cap screws to specifications; then tighten the two
"tamper-proof" torx-head cap screws to specifica-
tions.
14. Connect the fuel hoses to the fuel rail; then con-
nect the crankcase breather hose.
15. Connect the oil pressure switch connector to the
oil pressure switch.
16. Install the air filter assembly; then remove the tape
from the engine air intake boot and connect the air
intake boot. Tighten the boot clamp securely.
Back to Section TOC
DE451
DE295A
DE077B
Next