Arctic Cat 700 Diesel ATV 2007 Service Manual page 168

NOTE: To aid in removing the body without sep-
arating the front and rear panels, it is advisable to
have an assistant help with lifting and guiding the
body clear of the handlebar.
CLEANING AND INSPECTING
NOTE: Whenever a part is worn excessively,
cracked, or damaged in any way, replacement is
necessary.
1. Clean all fender components with a warm soap
and water solution.
2. Inspect fenders for cracks and/or loose rivets.
3. Inspect for any missing decals.
INSTALLING
1. Place the body assembly into position on the ATV.
NOTE: If the front and rear body panels have
been separated, proceed to step 2; if the panels
have not been separated, proceed to step 3.
2. Install the torx-head cap screws and lock nuts
securing the front and rear body panels together.
Tighten securely.
3. Making sure the body mounting grommets are in
place, position the front and rear racks; then install
the eight flanged cap screws and lock nuts. Do not
tighten at this time.
Back
8-10
CF213A
CF213A
Back to TOC
4. Install four rack-to-body machine screws and lock
nuts on the front and rear racks, two push nuts
behind the grille, and two body bolts adjacent the
air filter housing; then tighten all fasteners (from
step 3 and 4) securely.
Back to Section TOC
CD679A
CD690A
CF160A
CF201A
Next