Front Drive Selector Switch; Front Drive Selector Actuator - Arctic Cat 700 Diesel ATV 2007 Service Manual

3. With the starter button depressed, the meter must
show 0.5-0.7 DC volts.
4. With the starter button released, the meter must
show 0 DC volts.
5. Connect the red tester lead to the yellow/green
wire; then connect the black tester lead to the
orange/white wire.
6. With the starter button depressed, the meter must
show 0 DC volts.
NOTE: If the meter does not show as specified,
replace the switch/component, connector, or
switch harness.
RESISTANCE (Emergency Stop)
1. Set the meter selector to the OHMS position.
2. Connect the red tester lead to the orange wire; then
connect the black tester lead to the orange/white
wire.
3. With the switch in the OFF position, the meter
must show an open circuit.
4. With the switch in the RUN position, the meter
must show less than 1 ohm.
NOTE: If the meter shows more than 1 ohm of
resistance, troubleshoot
switch/component, the connector, or the switch
wiring harness.
Front Drive
Selector Switch
The connector is the two-wire black snap-lock one in
front of the steering post. To access the connector, the
cover must be removed.
NOTE: Resistance tests should be made with
the connector disconnected and on the selec-
tor-side of the connector.
RESISTANCE
! CAUTION
Always disconnect the battery when performing
resistance tests to avoid damaging the multimeter.
1. Set the meter selector to the OHMS position.
2. Connect the red tester lead to the red wire; then
connect the black tester lead to the white wire.
3. With the selector switch in the 2WD position, the
meter must show a closed circuit.
Back
5-8
or replace the
Back to TOC
4. With the selector switch in the 4WD position, the
meter must show an open circuit.
NOTE: If the meter does not show as specified,
replace the front drive selector switch.
VOLTAGE
NOTE: The battery must be connected when
performing voltage tests.
1. Set the meter selector to the DC Voltage position.
2. Connect the black tester lead to the negative bat-
tery terminal.
3. Connect the red tester lead to the red wire on the
harness side of the connector.
4. Turn the ignition switch to the RUN position.
5. The meter must show 12 DC volts.
NOTE: If the meter shows other than specified,
check the harness, connector, 30 amp fuse, and
battery connections.
Front Drive
Selector Actuator
NOTE: With the engine stopped and the ignition
switch in the ON position, a momentary "whirring"
sound must be noticeable each time the selector
switch is moved to 2WD and 4WD. Test the switch,
30 amp fuse, and wiring connections prior to test-
ing the actuator.
NOTE: The differential must be in the unlocked
position for this procedure.
VOLTAGE
1. Select the 2WD position on the front drive selector
switch; then disconnect the connector on the actu-
ator wiring harness.
2. With the ignition switch in the OFF position, con-
nect the black tester lead to the black wire in the
supply harness; then connect the red tester lead to
the orange wire in the supply harness.
3. Turn the ignition switch to the ON position. The
meter must show 12 DC volts.
4. Connect the red tester lead to the white/red wire in
the supply harness. The meter must show 12 DC
volts.
5. Select the 4WD position on the front drive selector
switch; then connect the red tester lead to the
white/red wire in the supply harness. The meter
must show 0 DC volts.
Back to Section TOC
Next