Adjusting Differential Lock Cable; Fuel Filter - Arctic Cat 700 Diesel ATV 2007 Service Manual

6. Place the V-belt cover gasket into position; then
install the cover and secure with the cap screws.
Tighten to specifications (see Section 10).
7. Secure the front fender to the footrest with the two
cap screws. Tighten securely.
8. Install the right-side footrest (see Section 8).
Adjusting Differential
Lock Cable
If the differential or differential lock system has been
serviced, the differential lock cable should be checked
and/or adjusted for proper free-play.
To adjust the cable, use the following procedure.
1. With the differential lock selector in the UNLOCK
position, slide the rubber boot (A) off the adjuster;
then loosen the jam nut (B). Turn the adjuster (C)
to achieve 6.35 mm (0.250 in.) of free-play mea-
sured at the end of the differential lock lever.
2. Select the 2WD position on the front drive selector
switch; then turn the ignition switch to the ON
position and select the LOCK position on the dif-
ferential lock selector. The front drive actuator
should operate engaging four-wheel drive.
NOTE: It may be necessary to turn the handlebar
or rock the ATV forward and backward to align the
differential lock splines and allow engagement.
Back
2-16
CD083
CD560A
Back to TOC
3. Return the differential lock selector to the
UNLOCK position and listen for the front drive
actuator to operate.
4. Turn the ignition switch to the OFF position.
Tighten the jam nut securely; then install the boot
on the adjuster.

Fuel Filter

This diesel-powered ATV is equipped with a high effi-
ciency fuel filter. The fuel filter should be changed in
accordance with the maintenance schedule or more
often if operated under severe conditions or winter
operation. To change the fuel filter, use the following
procedure.
1. Remove the right front fender splash panel; then
using an appropriate filter wrench, remove the fuel
filter.
2. Apply a light coat of oil to the seal ring of the new
fuel filter; then install the filter. Tighten until the
seal ring contacts the filter head; then tighten an
additional 3/4 turn.
3. Depress and release the manual primer pump to
charge the fuel filter and purge any air from the
system.
Back to Section TOC
DE032D
DE031A
Next