Arctic Cat 700 Diesel ATV 2007 Service Manual page 142

2. Inspect boots for any tears, cracks, or deteriora-
tion.
NOTE: If a boot is damaged in any way, it must
be replaced with a boot kit.
3. Inspect the gear case seals for nicks or damage.
DISASSEMBLING AXLES
1. Using a side-cutters (or suitable substitute),
remove the large clamp from the boot.
2. Wipe away excess grease to access the retaining
ring. Using an awl or snap ring pliers, remove the
circlip.
3. Using a snap ring pliers, remove the snap ring
securing the bearing ring to the shaft. Note the
direction of the bearing for assembling purposes.
Back
6-18
CD019
CD020
CD021
Back to TOC
4. Note the difference inside each bearing ring end
for assembling purposes; then remove the bearing
ring.
NOTE: The recess of the bearing must face
toward the housing.
5. Inspect the splines of the shaft, the bearing ring,
and the housing for damage.
NOTE: If any damage is apparent to the splines,
the bearing ring, and/or the housing, the drive axle
must be replaced as an assembly.
6. Using a side-cutters (or suitable substitute),
remove the small clamp from the shaft.
NOTE: At this point if the outside boot is dam-
aged, continue with step 7.
Back to Section TOC
CD023
CD022
CD752
Next