Arctic Cat 700 Diesel ATV 2007 Service Manual page 97

4. Install the front mounting bracket onto the engine
and secure with four cap screws. Tighten to speci-
fications.
5. Raise the front of the engine and install a cap
screw, two flat washers, and a nut securing the
front mounting bracket to the front engine mount.
Do not tighten at this time.
6. Install the cap screws, washers, and nuts in the left
rear, right rear, and upper right engine mounts.
Back
3-74
DE081A
DE083A
DE087A
Back to TOC
7. Tighten all engine mounting cap screws and nuts
to specifications.
8. Install the transmission level stick mount using a
new O-ring; then connect the throttle cable and
thread the throttle cable housing into the bracket.
Back to Section TOC
DE085A
DE090A
DE088A
DE091A
Next