Neutral Start/Front Drive Actuator/Start-In-Gear; Differential Lock/2Wd Relays; Headlights; Taillight - Brakelight - Arctic Cat 700 Diesel ATV 2007 Service Manual

Neutral Start/Front
Drive Actuator/
Start-in-Gear/
Differential Lock/
2WD Relays
The relays are identical plug-in type located on the
power distribution module. Relay function can be
checked by switching relay positions. The relays are
interchangeable.
NOTE: The module and wiring harness are not a
serviceable component and must be replaced as
an assembly.

Headlights

The connectors are the four 2-prong ones secured to
the front bumper supports (two on each side) with
cable ties.
BULB VERIFICATION
(Low and High Beam)
NOTE: Perform this test on each headlight bulb.
Also, a 12-volt external power supply w/jumpers
will be needed.
1. Disconnect the wiring harness from the bulb to be
tested.
2. Connect the power supply (positive) to one bulb
contact; then connect the power supply (negative)
to the remaining bulb contact.
3. The bulb should illuminate.
4. If the bulb fails to illuminate, it must be replaced.
VOLTAGE
NOTE: Perform this test in turn on the main har-
ness side of all four connectors. Also, the ignition
switch must be in the LIGHTS position.
NOTE: The LO beam is the outside bulb, and the
HI beam is the inside bulb.
1. Set the meter selector to the DC Voltage position.
2. Connect the red tester lead to one wire; then con-
nect the black tester lead to the other wire.
3. With the dimmer switch in the LO position, test
the two outside connectors (LO beam). The meter
must show battery voltage.
Back
5-12
Back to TOC
4. With the dimmer switch in the HI position, test the
two inside connectors (HI beam). The meter must
show battery voltage.
NOTE: If battery voltage is not shown in any
test, inspect the fuses, battery, main wiring har-
ness, connectors, or the left handlebar switch.

Taillight - Brakelight

The connector is the 3-prong one located under the
rear fender assembly.
VOLTAGE (Taillight)
NOTE: Perform this test on the main harness
side of the connector. Also, the ignition switch
should be in the LIGHTS position.
1. Set the meter selector to the DC Voltage position.
2. Connect the red tester lead to the white wire; then
connect the black tester lead to the black wire.
3. With the ignition key in the LIGHTS position, the
meter must show battery voltage.
NOTE: If the meter shows no voltage, inspect
fuses, wiring harness, connectors, and switches.
VOLTAGE (Brakelight)
NOTE: Perform this test on the main harness
side of the connector. Also, the ignition switch
should be in the ON position and the brake (either
foot pedal or hand lever) must be applied.
NOTE: Make sure the brake lever (hand) and
brake pedal (auxiliary) are properly adjusted for
this procedure.
1. Set the meter selector to the DC Voltage position.
2. Connect the red tester lead to the red/blue wire;
then connect the black tester lead to the black
wire.
3. With either brake applied, the meter must show
battery voltage.
NOTE: If the meter shows no voltage, inspect
bulb, fuses, wiring harness, connectors, and
switches.
Back to Section TOC
Next