Alternator/Regulator - Arctic Cat 700 Diesel ATV 2007 Service Manual

Table of Contents

Installing

1. Clean all gasket material from the surface of the

engine block.

2. Make sure the oil pump drive key in the crankshaft

is in the 3 o'clock position; then locate the oil

pump inner rotor keyway in the 3 o'clock position

as viewed from the crankshaft seal.

3. Install two alignment bolts in the engine block;

then install a new oil pump gasket into position on

the engine block.

4. Lubricate the crankshaft and crankshaft seal with a

liberal amount of engine oil; then install the oil

pump onto the crankshaft being careful not to

damage the oil seal.

NOTE: It may be necessary to rock the oil pump

slightly from side-to-side to engage the keyway

completely onto the key.

Back

3-42

DE265A

DE237A

DE266A

Back to TOC

! CAUTION

Never attempt to force the oil pump into position by

hammering or drawing in with the cap screws. The

inner rotor will be broken and severe engine damage

will occur.

5. Completely seat the oil pump against the engine

block; then secure with the existing hardware and

tighten to specifications. Note the correct cap

screw locations.

6. Install the alternator bracket and secure with the

three cap screws. Tighten securely.

7. Install the key in the crankshaft; then install the

timing belt drive pulley.

8. Install the timing belt (see Left-Side Components

in this section).