Arctic Cat 700 Diesel ATV 2007 Service Manual page 70

10. Remove the output driveshaft assembly (A).
Account for the bearing alignment C-ring in the
bearing boss next to the output driven bevel gear.
NOTE: Note the location of the bearing alignment
pin on the front output driveshaft bearing.
11. Remove the shift fork shaft (B); then remove the
high/low shift fork.
12. Remove the shift shaft (C) and account for two
thrust bearing races, one thrust bearing, and two
washers.
13. Remove the low/reverse shift fork; then remove
the input driveshaft (D).
NOTE: The shift forks are identical; therefore,
they may be used in either location. However, it is
advisable to return mating parts to their original
positions during assembling.
Back
DE133B
DE133C
DE138A
Back to TOC
14. Remove the countershaft assembly (E). Account
for a thrust washer on each end noting the different
sizes.
15. Remove the reverse idler gear (F). Account for the
axle, a bushing, and two thrust washers.
NOTE: The thrust washers on the reverse idler
gear are identical.
AT THIS POINT
If the drive bevel gear assembly (G), bearings, coun-
tershaft (E), seals, or output driveshaft assembly (A)
do not require servicing, no further disassembly is
required (proceed to Inspecting).
Back to Section TOC
DE139
3
DE142A
DE143A
Next
3-47