Arctic Cat 700 Diesel ATV 2007 Service Manual page 29

21. Remove the transmission level stick mount and
housing; then disconnect the throttle cable from
the throttle control arm and unthread the throttle
cable housing. Route the throttle cable away from
the engine.
22. Move the engine/transmission slightly forward
and shift the rear propeller shaft to the right; then
rotate the rear of the assembly out of the left side.
NOTE: The front engine mount bracket and fuel
filter housing can be removed to allow more clear-
ance at the front of the engine.
23. Remove the front propeller shaft from the trans-
mission output yoke; then slide the engine/trans-
mission out the left side lifting the transmission to
tilt the engine sufficiently forward for the top of
the engine to clear the upper frame tubes.
24. Attach a suitable lift and lift the engine free of the
frame.
Back
3-6
DE090A
DE091A
DE080A
Back to TOC
TRANSMISSION
NOTE: The transmission can be removed for ser-
vicing without removing the engine. To remove the
transmission, use the following procedure.
1. Remove the front rack, inner front splash shields,
foot pegs, and forward footwells; then remove the
front body panel (see Section 8).
2. Remove three cap screws securing the front pro-
peller shaft to the front differential input coupler.
3. Remove four cap screws securing the rear propel-
ler shaft to the output drive flange.
4. Remove the transmission level stick housing and
account for an O-ring.
5. Drain the transmission lubricant into a suitable
container; then disconnect the transmission vent
hose, gear shift position switch connector, speed
sensor connector, and shift linkage.
6. Remove the V-belt (see Section 2).
7. Remove the nut securing the driven pulley to the
transmission input shaft; then remove the driven
pulley. Account for a flat washer, square key, and
four shims.
8. Remove the nuts from the left rear and right rear
engine mount bolts; then remove the bolts.
Account for two flat washers.
Back to Section TOC
DE106A
DE108
Next