Water Pump - Arctic Cat 700 Diesel ATV 2007 Service Manual

7. Install the four cap screws and finger tighten; then
install the holding tool.
8. Apply Loctite #243 to the crankshaft pulley retain-
ing cap screw and tighten to specifications.
9. Tighten the four cap screws from step 7 to specifi-
cations.
10. Install the alternator belt and tighten so that 10 kg
(22 lb) of force at the belt midpoint results in
10-15 mm (0.4-0.6 in.) of deflection; then tighten
the mounting cap screws securely.
Back
3-40
DE214B
DE213
DE212
Back to TOC
11. Connect the shift linkage to the shift arm and
secure with the E-clip.
12. Install the front body panel; then install the front
rack. Tighten the existing hardware securely.

WATER PUMP

Removing
1. Remove the timing belt (see Left-Side Compo-
nents in this section).
2. Drain the coolant (see Section 4).
3. Remove the lower radiator hose and the coolant
bypass hose from the water pump; then remove
four cap screws securing the water pump and
remove the water pump.
4. Thoroughly clean all gasket material from the
engine block and water pump.
Servicing
NOTE: The water pump is not a serviceable com-
ponent. If it is defective, it must be replaced as an
assembly.
Installing
1. Make sure all mating surfaces are free of any gas-
ket material, sealant, or residue.
2. Using a new gasket, install the water pump onto
the engine and secure with the four cap screws.
Tighten to specifications.
Back to Section TOC
DE103B
Next