Arctic Cat 700 Diesel ATV 2007 Service Manual page 21

5. Using a block of wood and a mallet, drive the
V-belt down between the sheaves of the driven
pulley approximately one inch; then making sure
not to dislocate the one-way clutch from the fixed
drive hub, squeeze the belt together and remove
from the drive clutch.
INSTALLING
1. Place the V-belt into position over the driven pul-
ley noting the directional arrows on the V-belt.
NOTE: The diesel engine in this ATV rotates
counterclockwise as viewed from the right side;
therefore, if directional arrows are printed on the
V-belt, they must be directed rearward.
Back
DE097A
DE098A
DE488
Back to TOC
2. Using a block of wood and a mallet, drive the
V-belt down between the sheaves of the driven
pulley approximately one inch; then squeeze the
belt together and slide over the fixed drive hub and
onto the one-way clutch.
3. Pinch the V-belt together near its center and slide
the movable drive face onto the drive hub. Secure
the drive face with a nut. Tighten the nut to speci-
fications (see Section 10).
NOTE: At this point, the wedge can be removed
from between the driven pulley faces.
4. Rotate the V-belt and pulley until the V-belt is
flush with the top of the driven pulley.
5. Install the cap screw securing the drive clutch
assembly to the flywheel/PTO shaft and tighten to
specifications (see Section 10).
Back to Section TOC
2
DE097A
DE098A
DE483
Next
2-15