Arctic Cat 700 Diesel ATV 2007 Service Manual page 53

2. Secure the engine on a suitable stand.
3. Remove the timing belt (see Left-Side Compo-
nents in this section).
4. Remove the unit injectors (see Top-Side Compo-
nents in this section).
5. Remove the lift pump and lift pump push rod (see
Section 4).
6. Rotate the crankshaft to approximately 90° after
top-dead-center (ATDC).
7. Turn the camshaft drive pulley until the camshaft
and rocker arms are "unloaded" (all rocker arms in
"valve-closed" position).
! CAUTION
Do not rotate camshaft with the crankshaft in the
TDC position or severe engine damage will occur.
8. Remove the three nuts securing the rocker arm
shaft; then using rubber bands or a large O-ring
secure the rocker arms together.
Back
3-30
DE240A
DE275A
Back to TOC
9. Lift the rocker arm assembly from the cylinder
head. Account for three washers.
10. Remove the six cap screws securing the cylinder
head to the engine block and remove the cylinder
head assembly. Account for six flat washers, a cyl-
inder head gasket, and two alignment pins.
Back to Section TOC
DE307
DE584
DE575A
Next