Differential Lock Switch; Starter/Starter Solenoid - Arctic Cat 700 Diesel ATV 2007 Service Manual

NOTE: The 4WD icon on the LCD should illumi-
nate.
6. Connect the red tester lead to the orange wire in
the supply harness. The meter must show 12 DC
volts.
NOTE: If the voltage readings are as specified
and the actuator does not function correctly,
replace the actuator (see Section 6).
Differential Lock
VOLTAGE
1. Select DC Voltage on the multimeter; then connect
the red tester lead to the switch terminal (leaving
the wire connected) and the black tester lead to
ground.
2. Turn the ignition switch to the ON position. The
meter must show 12 DC volts.
NOTE: If no voltage is indicated, check the wir-
ing harness, fuse, or battery connections.
3. Select the lock position on the differential. The
meter should drop to 0 volts, and the front drive
selector actuator switch should operate to engage
4-wheel drive.
NOTE: It may be necessary to rock the ATV
slightly to engage the differential lock fully.
NOTE: The 4WD and the LOCK icons on the
LCD should illuminate.
Back
Switch
Back to TOC
4. If the differential lock engages (front wheels
locked) and the voltage does not drop to 0, the
switch is faulty and must be cleaned or replaced.

Starter/Starter Solenoid

NOTE: The starter is not a serviceable compo-
CD575
nent and must be replaced as an assembly. Before
replacing the starter, troubleshoot the starter volt-
age, starter relay, neutral start, and start-in-gear
relays.
To replace the starter, use the following procedure.
REMOVING
1. Remove the negative battery cable from the bat-
tery.
2. Remove the left-side inner fender splash panel;
then remove the seat and the left-side engine
cover.
3. Disconnect the battery cable and the starter wire
from the starter solenoid; then remove the two cap
screws securing the starter to the V-belt housing.
INSTALLING
1. Place the starter into position in the V-belt hous-
ing; then secure with the two cap screws and
tighten to specifications.
Back to Section TOC
CD576
CF094C
5
Next
5-9