Arctic Cat 700 Diesel ATV 2007 Service Manual page 147

2. Inspect all threads for stripping or damage.
3. Inspect the brake disc for cracks or warping.
4. Inspect the hub for pits, cracks, loose studs, or
spline wear.
INSTALLING
1. Secure the brake disc to the hub with the four cap
screws coated with blue Loctite #243. Tighten to
specifications.
2. Apply grease to the splines in the hub.
3. Install the hub assembly onto the shaft.
4. Secure the hub assembly with the nut. Tighten
only until snug.
5. Secure the brake caliper to the knuckle with the
two cap screws. Tighten the auxiliary caliper to
specifications. Tighten the hydraulic caliper to
specifications.
Back
PR291
CD009
Back to TOC
6. Tighten the hub nut (from step 4) to specifications;
then install and spread a new cotter pin making
sure each side of the pin is flush to the hub nut.
7. Install the wheel and tighten to specifications.
8. Remove the ATV from the support stand.
Back to Section TOC
PR243A
CD008
6
CD006
Next
6-23