Arctic Cat 700 Diesel ATV 2007 Service Manual page 79

5. Install the high/low shift fork and engage the fork
in the high/low cam slot in the gear shift shaft;
then install the shift fork shaft.
6. Install the secondary output driveshaft aligning the
front bearing alignment ring with the groove in the
gear case and rotate the bearing to locate the bear-
ing anchor pin in the slot; then align the groove in
the rear bearing with the case groove and install
the C-ring.
7. Apply a thin layer of Three Bond Sealant to the
mating surface of the right-side gear case; then
make sure that the alignment pins and washers are
positioned as shown and join the gear case halves.
Do not force the gear case halves together.
Back
3-56
DE136A
DE135A
DE133C
Back to TOC
8. From the right side, install the gear case cap
screws and using a crisscross pattern, tighten until
the gear case halves are finally joined, turning the
shafts frequently to assure no binding occurs; then
tighten to specifications.
9. Install the speed sensor trigger and secure with the
circlip; then install the speed sensor housing and
secure with the cap screws. Tighten securely.
Back to Section TOC
DE133D
DE130B
DE126
Next