Arctic Cat 700 Diesel ATV 2007 Service Manual page 49

3. Remove the valve cover. Account for a gasket and
the oil return boot.
Back
3-26
DE074A
DE294A
DE077B
DE405B
Back to TOC
NOTE: The valve cover has two "tamper-proof"
torx-head cap screws that can be removed by
using a special Torx-Head Screwdriver - #30 (p/n
0644-344).
4. Rotate the engine clockwise until either cylinder is
at TDC as shown in the following illustration.
5. Using an appropriate thickness gauge, check the
clearance between the camshaft follower and cam-
shaft.
6. To adjust the clearance, loosen the jam nut (A);
then rotate the adjuster (B) to obtain the specified
clearance (C).
7. When proper clearance is attained, tighten the jam
nut (A) while holding the adjuster (B); then tighten
the jam nut to specifications and check clearance
(C).
Back to Section TOC
DE557A
DE642A
DE429A
Next