Starter Relay; Alternator/Regulator - Arctic Cat 700 Diesel ATV 2007 Service Manual

2. Connect the battery cable to the starter solenoid;
then connect the starter relay wire to the spade ter-
minal on the starter solenoid.
3. Install the inner splash panel, engine cover, and
seat; then connect the negative battery cable to the
battery. Tighten securely.
TESTING VOLTAGE
Perform this test on the starter solenoid starter relay
terminal.
NOTE: The ignition switch must be in the ON
position, the emergency stop switch in the RUN
position, and the shift lever in the NEUTRAL posi-
tion.
1. Set the meter selector to the DC Voltage position.
2. Connect the red tester lead to the spade terminal;
then connect the black tester lead to ground.
3. With the starter button depressed, the meter must
show battery voltage and the starter motor should
operate.
NOTE: If the meter showed battery voltage but
the starter did not operate or operated slowly,
inspect battery voltage (at the battery), starter
motor condition, and/or ground connections.
NOTE: If the meter showed no battery voltage,
inspect the main fuse, ground connections, starter
motor lead, battery voltage (at the battery), starter
relay, or the neutral start relay.
Back
5-10
DE653A
DE653B
Back to TOC

Starter Relay

1. Remove the seat; then using the multimeter set to
the DC Voltage position, check the relay as fol-
lows.
2. Connect the red tester lead to the battery terminal;
then connect the black tester lead to the starter
solenoid cable connection on the starter relay. The
meter must show battery voltage.
NOTE: Make sure that the ignition switch is in
the ON position, transmission in neutral, brake
lock released, and the emergency stop switch in
the RUN position.
3. Depress the starter button while observing the
multimeter. The multimeter should drop to 0 volts
and a "click" should be heard from the relay.
NOTE: If a "click" is heard and any voltage is indi-
cated by the multimeter, replace the starter relay. If
no "click" is heard and the multimeter continues to
indicate battery voltage, proceed to step 4.
4. Disconnect the two-wire plug from the starter
relay; then connect the red tester lead to the green
wire and the black tester lead to the black wire.
5. Depress the starter button and observe the multim-
eter.
NOTE: If battery voltage is indicated, replace
the starter relay. If no voltage is indicated, proceed
to Neutral Start Relay check.

Alternator/Regulator

TESTING
Prior to performing the following tests, make sure the
alternator belt is properly tightened and the battery is
fully charged.
Back to Section TOC
DE002B
Next