Checking/Replacing V-Belt - Arctic Cat 700 Diesel ATV 2007 Service Manual

To check/add coolant, use the following procedure.
1. Check the level of coolant in the coolant expan-
sion tank located under the right front fender. The
coolant level should be between the Full Cold and
Full Hot lines.
2. Remove the rubber plug from the neck of the cool-
ant expansion tank and add coolant as necessary;
then install the plug.
3. Remove the filler cap and add coolant as necessary
to bring coolant level to the top of the filler neck.
Install and tighten the filler cap.
Checking/Replacing
REMOVING
1. Remove the right-side footrest (see Section 8).
2. Remove the cap screws securing the V-belt cover;
then using a rubber mallet, gently tap on the cover
tabs to loosen the cover. Remove the cover.
3. Remove the cap screw securing the drive clutch to
the flywheel stub axle; then remove the nut and
lock washer securing the movable drive face to the
fixed drive hub.
Back
2-14
V-Belt
Back to TOC
DE019A
4. Remove the movable drive face using care to keep
the face plate tight against the drive face to prevent
the weights from falling out. Account for a spring
seat, spring, bushing, and lock washer.
DE582A
Back to Section TOC
DE093A
DE095
DE096A
DE094A
Next