Arctic Cat 700 Diesel ATV 2007 Service Manual page 94

22. Repeat steps 15-21 for the second piston.
23. Install the oil pump (see Section 4).
24. Install the water pump (see Section 4).
25. Install the cylinder head (see Top-Side Compo-
nents in this section).
26. Cover the ends of the lateral seals with RTV Sili-
cone; then place a new oil pan gasket in place
making sure to properly align the gasket with the
oil sump and return galleys.
27. Install new O-rings on the oil sump and return
pipes; then apply oil-soluble grease on the O-rings
and place the oil pan into position.
Back
DE439
DE440B
DE410
Back to TOC
28. Secure the oil pan with the Allen-head cap screws
and the two hollow studs and spacers making sure
to install the two hollow studs at the outside cor-
ners on the crankshaft pulley side; then using a
crisscross pattern, tighten to specifications.
29. If the oil pan cover was removed, place two new
gaskets onto the oil pan; then install the oil pan
cover and secure with the Allen-head cap screws.
Tighten in a crisscross pattern to specifications.
30. Install the coolant bypass hose and secure with the
support clamps and two Allen-head cap screws to
the two hollow studs; then secure the bypass hose
to the fittings with the hose clamps. Tighten
securely.
31. Install a new crankshaft seal in the rear engine seal
flange; then apply a small amount of RTV Silicone
to the extended ends of the lateral seals.
Back to Section TOC
DE596A
3
DE442A
DE442A
Next
3-71