Flywheel/Pto/V-Belt Housing - Arctic Cat 700 Diesel ATV 2007 Service Manual

4. Remove the adjuster cap screw and pivot bolt and
remove the alternator.
Servicing
NOTE: The alternator/regulator is not a service-
able part; therefore, it must be replaced as an
assembly.
Installing
1. Place the alternator/regulator into position on the
engine; then secure with the existing hardware. Do
not tighten at this time.
2. Place the alternator drive belt into position; then
using a suitable pry, tension the drive belt so that a
10 kg (22 lb) force applied at the midway point will
result in a deflection of 10-15 mm (0.4-0.6 in.).
Back
DE519C
DE103C
DE103B
Back to TOC
3. Holding tension on the belt, tighten the adjuster
cap screw securely; then remove the pry and
tighten the pivot bolt securely.
4. Connect the battery (B+) wire and connect the reg-
ulator control plug-in; then connect the negative
battery cable to the battery.
5. Install the-left side engine cover and seat making
sure the seat latches securely.
Right-Side Components
NOTE: For efficiency, it is preferable to remove
and disassemble only those components which
need to be addressed and to service only those
components. The technician should use discretion
and sound judgment.
AT THIS POINT
To service any one specific component, only limited
disassembly of components may be necessary. Note
the AT THIS POINT information in each sub-section.
NOTE: The engine/transmission does not have to
be removed from the frame for this procedure.
AT THIS POINT
If the technician's objective is to service/inspect the
V-belt cover, driven pulley, or drive clutch, see Sec-
tion 2.

FLYWHEEL/PTO/V-BELT HOUSING

Removing
1. Remove the transmission
Engine/Transmission - Transmission in this sec-
tion).
2. Using Drive Clutch Puller (p/n 0444-226), remove
the fixed drive face/clutch hub.
3. Remove two cap screws securing the starter to the
V-belt housing; then remove the starter.
Back to Section TOC
3
(see Removing
DE099A
Next
3-43