Static Injector Timing - Arctic Cat 700 Diesel ATV 2007 Service Manual

8. Rotate the crankshaft clockwise 180° and repeat
steps 5-7 on the other cylinder.
AT THIS POINT
If engine is being assembled, static injector timing
should be adjusted (see Top-Side Components in
this section).
9. Place a small bead of high-temperature sealant on
the fuel rail seal; then carefully install the valve
cover with a new gasket and oil return boot.
Tighten to specifications.
10. Connect the oil pressure switch connector and the
crankcase ventilator hose; then install the air filter
assembly and secure with the existing hardware.
Tighten securely.
11. Install the front body panel; then install the front
rack and splash panels (see Section 8).

STATIC INJECTOR TIMING

To set static injector timing, use the following proce-
dure.
1. Remove the valve cover and fuel rail (see Unit
Injectors in this sub-section).
2. Install the Timing Fuel Block (p/n 0444-234) on
the injector using the eccentric gasket over the
check valve in place of the O-ring.
Back
DE406
DE405B
Back to TOC
3. Connect a suitable container filled with clean die-
sel fuel to the supply fitting using an inlet hose;
then place a small cup under the bleed hose.
4. Rotate the engine in the direction of rotation
(clockwise) until the #2 (flywheel-side) piston is at
top-dead-center (TDC) on the compression stroke
(reference mark (D) aligned to TDC index mark
(A) and valves closed).
Back to Section TOC
DE572
3
DE444A
DE403B
Next
3-27