Steering/Frame; Steering Post/Tie Rods - Arctic Cat 700 Diesel ATV 2007 Service Manual

Steering/Frame

NOTE: Critical torque specifications are located
in Section 10.
Steering Post/
Tie Rods
NOTE: Some components may vary from model
to model. The technician should use discretion
and sound judgment.
REMOVING
1. Remove the ignition switch retaining ring; then
remove the reinstallable rivets securing the instru-
ment pod to the mounting bracket and remove the
pod.
NOTE: It is not necessary to disconnect any
wires from instrument pod components.
2. Remove the reinstallable rivets securing the radia-
tor access cover and remove the cover.
3. Remove the reinstallable rivets securing the steer-
ing post cover and remove the cover.
8-2
CD759
CD666
Back to TOC
4. Unlatch the storage compartment lid; then slide
the storage compartment cover assembly forward
and lift off.
5. Remove the four cap screws securing the handle-
bar caps and instrument pod bracket to the steering
post; then move the handlebar out of the way.
Account for four handlebar caps.
6. Remove two cap screws securing the upper steer-
ing post bearing to the frame. Account for two
bearings and two housings.
7. Using a suitable lift stand, raise the ATV enough
to remove the front wheels; then remove the
left-side and right-side splash panels.
8. Remove the cotter pins and slotted nuts from the
inner and outer tie rod ends; then remove the tie
rods from the steering post arm and the left-side
and right-side steering knuckles.
Back to Section TOC
CD667
CD760
CD685
Next