Engine Rpm (Idle); Engine Oil - Filter - Arctic Cat 700 Diesel ATV 2007 Service Manual

2. Turn the adjuster until the throttle cable has proper
free-play of 3-6 mm (1/8-1/4 in.) at the lever.
3. Tighten the jam nut against the throttle cable
adjuster securely; then slide the rubber boot over
the adjuster.

Engine RPM (Idle)

NOTE: The idle RPM is not adjustable on the 700
Diesel.

Engine Oil - Filter

Change the engine oil and oil filter at the scheduled
intervals. The engine should always be warm when the
oil is changed so the oil will drain easily and com-
pletely.
1. Park the ATV on level ground.
2. Remove the engine oil filler cap.
Back
2-6
AL611D
ATV-0047
Back to TOC
3. Remove the drain plug from the bottom of the
engine and drain the oil into a drain pan.
4. Remove the right-side engine cover.
5. Using the adjustable Oil Filter Wrench (p/n
0644-389) and a suitable wrench, remove the old
oil filter.
NOTE: Clean up any excess oil after removing
the filter.
6. Apply oil to a new filter O-ring and check to make
sure it is positioned correctly; then install the new
oil filter. Tighten until contact is made; then
tighten an additional 1 1/2 turns.
NOTE: Install a new O-ring each time the filter is
replaced.
Back to Section TOC
DE025A
DE017A
DE018
Next